IKIDI 6 CV - Electrique 48 Volt

New electric motor
PMSM technology (permanent magnet synchronous)
Nominal voltage: 48 V
Max current: 120 A
Nominal power: 5,100 W
Water cooling
Short or long shaft - solid bar

The casing and base are of YAMAHA design, only the drive head has been replaced by an electric motor. Relying on proven, reliable mechanics, we arrive at a simple, highly efficient, and cost-effective solution.
The drive heads use PMSM technology, a permanent magnet synchronous motor, which requires no maintenance and is rated for a minimum of 10,000 hours of use.

Power inverters are Sevcom type. They come from industrial equipment with high engagement such as forklifts, sweepers, pallet trucks, and are also highly reliable.

The entire system is cooled by open circuit water driven by the turbine located in the base, similar to an internal combustion engine.
You can use it in freshwater or saltwater with, as with any outboard motor, mandatory rinsing after use.
The only periodic maintenance needed is oil change of the lower unit and replacement of the cooling turbine.
The propeller is made of aluminum.

Wear parts, propellers, turbines, motor covers, etc...., are standard references.
The warranty is 2 years, parts and labor.

Shaft length & controls
The 6HP model is offered with short or long shaft, solid bar.
The 15HP model is offered with short or long shaft, solid bar or remote controls.
Connection kit
Each motor comes with 2 meters of 16mm² electrical cable, a resettable thermal circuit breaker, a coulomb meter monitor showing real-time battery status and remaining range based on the motor’s consumption.
Batteries
The lithium batteries offered with the motors are LiFePo4 type.
For the 6HP:
One 48 Volt 105Ah battery that offers 1 hour or 20 kilometers of range at full throttle. Additional batteries can be added in parallel to increase autonomy.
For the 15HP:
One 72 Volt 202Ah battery.
Note that we can custom-build batteries according to the boat's storage compartment dimensions.